Reader David is seeking information about this ArmaLite marked 4-14×50 scope. I have looked through my limited number of ArmaLite catalogs and I am coming up empty. Any help would be appreciated.
Well at least a few of them. According to the accepted timeline (Click Here) the first 12 AR-180 rifles were made in July 1969. 50 years ago this month.
As time marches on more and more will become Curio & Relics. Time to get your C & R FFL so we can start selling and trading these among each other. Best part, they can be mailed directly to your house!
The real question is, how do we get those who are selling them to agree they now fall under the C & R classification and it would be perfectly legal to ship them to me?
One thing is for sure, in 3 years all Costa Mesa AR-180’s will qualify for C & R status.
I welcome you comments on this. What do you think?
Good friend of the site Oscar sent me an upper that another gunsmith attempted to remove the barrel on. He got it back from said gunsmith with the message that he was unable to remove the barrel and afterwords he was unable to tighten the barrel back up.
What many do not know is that the AR180B has a unique method of barrel retention and it is not at all obvious.
If we look at a bare trunion you will note that it has a large hole through the middle with a small step.
The barrel for this gun uses an AR15 barrel extension that is turned down and press fit into this trunion. That’s it! Nothing else. Just a press fit.
What happens then when the unsuspecting gun plumber puts a barrel wrench on the barrel and clamps that flat sided receiver in his vise? It makes funny noises and turns the extension in the trunion. Not good. Oscar mentioned that it shot terrible after he got it back and I suggested he send it to me for inspection. It didn’t take long to figure out my initial thoughts were correct.
Now how do I fix it so it is safe to shoot? I want to thank Oscar for being patient with me as I have had his upper for quite some time while I try to figure out what to do.
I settled on a shallow pin. I wanted it to not show unless you were looking for it and still be able to hold everything secure.
Sneaking the Tig torch in between the bosses was challenging but ended up with good penetration after I got the amperage dialed in.
So what is the right way to remove a barrel for the 180 Bravo? Use a modified reaction wrench. Do not put any twisting force on the receiver itself.
I now have everything needed to offer shorty conversions or to sell the parts outright if you want to roll your own. CNC machined from billet steel these new hand guard caps will retain the cut down hand guards on an AR180 or 180B. Shoot me a message through the contact form if you need more details.
Interesting things in this picture for sure. Lets start with what looks normal. the bolt, cam pin, firing pin and spring. That’s about it. Straight charging handle, shown here upside down. Similar to the AR180B but those are solid on the underside. Bolt carrier, a lightening cut out is full length as opposed to the partial cutout on the first 1000 Howa’s. Those were expected and had been seen before on other pictures like those of serial number X01. What wasn’t expected was the firing pin retainer. It has a split end not unlike the early solid version in the Colt 601.
A wider shot shows the guide rod assembly. These did not feature a latch as I believe it was found during testing that the rear plate would bounce when struck by the bolt carrier and unlock the upper from the lower. Not the kind of thing you want to happen in a fire fight.
What else do you see? Let me know in the comments and please share these articles with your friends.